Description
45° Engraving Tool Holders
- Carbide shank holders designed for shrink-fit holders, engraving machines & high speed cutting
- 100mm length application is only Al, Al-alloy cutting, unbalanced <0.6gm
| Part Number | Holder | d (mm) | L (mm) | Screw | Wrench |
| OM14351 | CET 0206040 | 6 | 40 | OM14357 (TSB-22045) |
OM14055 (T6) |
| OM14352 | CET 0206065C | 65 | |||
| OM14353 | CET 0206100C | 100 |
Recommended Cutting Data
|
Material |
S RPM |
Feed (mm/rev) |
Insert Grade |
||
|
P |
<30HRC |
5,000-20,000 |
0.02-0.05 |
VPGT 060202-45M |
|
|
30-45HRC |
5,000-20,000 |
0.01-0.02 |
VPGT 060202-45P |
||
|
M |
<40HRC |
5,000-20,000 |
0.02-0.05 |
VPGT 060202-45M |
|
| K (Cast Iron) |
30-45HRC | 5,000-20,000 | 0.01-0.02 | VPGT 060202-45P | |
|
N |
Al, Al-alloy |
5,000-20,000 |
0.02-0.08 |
VPGT 060202-45N |
|
Recommended Peck Cycle on Engraving Depth
| Material | AP | |||||||||
| 1st | 2nd | 3rd | 4th | 5th | 6th | ~ | Fine finishing | Tmax. | ||
| P (Steel) |
Carbon Steel C < 0.3% | 0.6 | 0.4 | 0.3 | 0.2 | 0.2 | 0.2 | 0.1 | 0.1 | 2 |
| Carbon Steel C > 0.3% | 0.8 | 0.6 | 0.3 | 0.2 | 0.1 | - | - | 0.1 | 2 | |
| Low Alloy Steel C < 0.3% | 0.5 | 0.4 | 0.3 | 0.3 | 0.2 | 0.2 | 0.1 | 0.1 | 2 | |
| High Alloy Steel C > 0.3% | 0.3 | 0.3 | 0.2 | 0.2 | 0.15 | 0.15 | 0.1 | 0.05 | 1.4 | |
| Alloy Steel 30-45HRC | 0.2 | 0.2 | 0.15 | 0.15 | 0.1 | 0.1 | 0.1 | 0.05 | 1 | |
| M (Stainless Steel) |
Stainless Steel | 0.5 | 0.4 | 0.3 | 0.3 | 0.2 | 0.2 | 0.1 | 0.05 | 2 |
| K (Cast Iron) |
Cast Iron | 0.8 | 0.6 | 0.3 | 0.2 | 0.1 | - | - | 0.1 | 2 |
| N (Non Ferrous) |
Non Ferrous | 1 | 0.8 | 0.2 | - | - | - | - | 0.1 | 2 |
